Contact Parallax sales department if any parts are missing. Otherwise, continue with the Caster Wheel Kit assembly section instructions.
Locate the triangular base plate and the swivel rod. Notice that there is a machined “flat” on the swivel rod.
The bearing on the bottom (as shown below) should simply slide in and drop into (and rest on) the bearing’s flange. Conversely, the top bearing will slide “in and up” into the bearing cavity, so that the two “flanges” are facing each other.
Once the shaft collar is installed (next Step), it will prevent the bearings from falling out.
The gap between the triangular plate and the to of the swivel block should be approximately on tenth of an inch. You can make fine adjustments after they’re mounted on the Arlo deck.
The six remaining #6x3/8”socket-head screws will be used in the next Section.