IMPORTANT! IF YOU PURCHASED YOUR ELEV-8 V3 KIT AFTER FEBRUARY 2016 AND/OR HAVE MOTORS WITH TWO (2) SET SCREWS – SKIP THIS STEP AND GO TO STEP 2: ATTACH MOTORS TO MOTOR MOUNTS.
For users with V3 kits purchased before February 2016, and/or users with motors that have only one (1) set screw, please complete this step. Here you will apply Loctite® to the motor set screws to prevent them from loosening during flight and potentially causing equipment failure.
Using the hex key, carefully remove the motor set screw from each motor. The screws may be very tight; be careful not to break your hex key.
Tip! To open the Loctite® twist off the cap. When you are done, use the other end of the cap to seal the Loctite®, you'll need it a few more times in the assembly process.
3. Allow the Loctite® to set for 10 minutes; it will fully cure in 24 hours.