Available for Propeller Activity Board, FLiP, and Other board types. Not available for Badge or Scribbler Robot board types. I/O pin range options will vary with board type.
These blocks use a BME680 Environmental Sensor Module (#28061) [1]
The Air Quality initialize block sets up the BME680 sensor. If you forget to use this block, other Air Quality sensor blocks will remind you with a triangle-shaped warning icon:
From the drop-down menus, select the Propeller I/O pin numbers that are connected to the sensor module's SCK, SDI, SDO, and CS pins.
The Air Quality read block instructs the BME680 sensor to take a set of measurements and store them. This block should be used immediately before using an Air Quality get value block.
The Air Quality get value retrieves the specified sensor reading from the last time the Air Quality read block was used.
The Air Quality heater is used to enable or disable the internal heating element inside the BME680 sensor.
Links
[1] https://www.parallax.com/product/28061