Step 3 - Prepare Chassis

Chassis Preparation

For all ActivityBot Robots.

Parts needed for this step:

  • Chassis (#700-00022)
  • Grommet (#700-00025)
  • (2) 1/4" pan-head screws (#700-00028)
  • (2) 1-inch long round standoffs (#700-00060)

  • Push the rubber grommet through the round hole in the chassis. A groove in the grommet should fit over the edge of the metal, leaving a ring visible on both sides.

  • Attach a 1-inch standoff to each outer-most hole in the front of the robot chassis.  Use a 1/4-inch pan-head metal screw (these have a little dome on top with an x for the Philips-tip screwdriver). Insert the screw from underneath and twist the standoff on to it from the top. 

Prepared chassis: