- (2) Whisker wires
- (2) 3-pin headers
- (2) 10 kΩ resistors (brown-black-orange)
- (2) 220 Ω resistors (red-red-brown)
Adding the Whiskers
- Loosen the two screws that attach the front of your board to the chassis standoffs.
- Hook a whisker wire onto each screw, positioned as shown in the diagram below.
- Make sure to set one whisker above the nylon washer, and the other below, as shown here.
- Gently re-tighten the screws, making sure the edge of the wire is parallel to the edge of the breadboard.
Build the Circuit
The next picture shows whisker wiring. Along with the whisker circuits, it has the same piezospeaker we've been using.
- Build the circuit as in the picture.
- Make sure to leave some space between the whiskers and the 3-pin headers.
- Also, make sure that the 10 kΩ resistors (brown-black-orange) are the ones that connect 3.3 V sockets to the rows with the 3-pin headers.
- Likewise, the 220 Ω (red-red-brown) resistors should connect P8 and P7 to the 3-pin header rows.
*P14/P15 resistors are needed only for ActivityBot kits using External Encoders (#32500).