Chassis Preparation

For All ActivityBot Robots

Parts for this step:

• Chassis (#700-00022)
• Grommet (#700-00025)
• (2) 1/4" pan-head screws (#700-00028)
• (2) 1-inch long round standoffs (#700-00060)

• Push the rubber grommet through the round hole in the chassis. A groove in the grommet should fit over the edge of the metal, leaving a ring visible on both sides.

• Attach a 1-inch standoff to each outer-most hole in the front of the robot chassis.  Use a 1/4-inch pan-head metal screw (they have a little dome on top with an x for the Philips-tip screw driver.) Insert the screw from underneath and twisth the standoff on to it from the top. 

Prepared chassis: