3-position Switch
If your board has a 3-position switch, you can set it to 1 or 2. 1 will power the microcontroller and the sockets alongside the white breadboard. 2 will also power the 3-pin headers above the breadboard.
Need help? Email support@parallax.com [3], or visit the Learn Forum [4].
Found a bug? Please report it to the SimpleIDE Open Source Project [5] site's Issues [6]page.
QuickStart Rev A Note: “Error: load fail” messages are occasionally seen when using the QuickStart Rev A with the SimpleIDE programming software. To remedy this, insert a 10 k-ohm pull-up resistor into the Accessory Socket as shown below. This is not necessary with QuickStart Rev B boards.
Links
[1] https://www.parallax.com/package/simpleide-software-for-mac-propeller-c/
[2] https://learn.parallax.com/tutorials/language/propeller-c/propeller-c-set-simpleide/update-your-learn-folder
[3] mailto:support@parallax.com?subject=Help%20with%20SimpleIDE%20Mac%20Installation
[4] http://forums.parallax.com
[5] https://code.google.com/p/propside/
[6] http://code.google.com/p/propside/issues/list