If you like Halloween and you like tacos, then you’ve come to the right place my friends! In this tutorial I do a “show and tell” of how I made a crawling piñata taco. Since the parts you end up using may vary (depending on whether you have access to a laser cutter) this tutorial is more of a guide rather than a step by step instruction manual. Let’s get started!
Parts Used:
- (1) – Taco Pinata
- (2) – Creepy eyeballs
- (8) – Pipe Cleaners
- (3) – Jumper wires
- (2) – Feedback 360° servos (#900-00360)
- (1) – 5 AA Battery Pack (#)
- (1) – 40-pin single row header (#) OR, (10 to 15) – 3-pin single row headers (#451-00303)
- (4) – L-shaped Mounting Brackets (#720-00011)
- (1) – PIR Sensor (#555-28027)
- (1) – Activity Board WX (#32912)
- (10) – #4-40 pan head screws
- (8) – #4-40 nuts
- (8) – #4-40 flat head screws
- (2) – Small Robot Wheel & Tire (#28114) (optional – required only if not laser cutting custom parts)
Tools Used:
- Glue Gun
- Drill with ⅛” drill bit
- Phillips screwdriver
CAUTION: Always wear safety glasses when working with drills, hot glue, laser cutters or other tools!
Curriculum
- 1 Section
- 3 Lessons
- Lifetime
Expand all sectionsCollapse all sections
