Section 5: Install the Electronics
In this section, you will install the isolation assembly and electronics in your ELEV-8 v3 Quadcopter, following the 4 steps below.
This section will take approximately 30 to 60 minutes, depending on your skill level and equipment.
Tools Needed in this Section
Parts Needed in this Section
- 1 – Chassis Assembly from Section 4
- 4 – Vibration Damper, 80g (#700-00098)
- 1 to 4 – Zip Tie, 5.9″ length (#700-00099)
- 6 – 3-Wire Servo Extension Cable, 6″, Beveled (#800-00043)
- 1 – ELEV-8 PDB Power Cable, 6″ (#800-00300)
- 1 – RC Radio Receiver (not included)
- 1 – Fully Charged 3-Cell LiPo Battery w/ EC3 connector (not included)
