Section 6: Software and Firmware
In this section, you will configure your transmitter, install the GroundStation software, and update and configure your flight controller firmware, follwing the 4 steps below.
This section will take approximately 1 to 2 hours, depending on your skill level and equipment.
Parts Needed in this Section
- ELEV-8 v3 Assembly w/ LiPo Battery, prepared in Section 5
- Fully Charged RC Radio Transmitter (not included)
- RC Reciever Bind Plug (not included)
- SD Card & SD Card Reader (optional)
- Computer running Windows 7/8/10 with internet connection (not included)
- USB A to Micro B cable (not included)
