Chassis Preparation
For All ActivityBot Robots
Parts for this step:
- Chassis (#700-00022)
- Grommet (#700-00025)
- (2) 1/4" pan-head screws (#700-00028)
- (2) 1-inch long round standoffs (#700-00060)
- Push the rubber grommet through the round hole in the chassis. A groove in the grommet should fit over the edge of the metal, leaving a ring visible on both sides.
- Attach a 1-inch standoff to each outer-most hole in the front of the robot chassis. Use a 1/4-inch pan-head metal screw (they have a little dome on top with an x for the Philips-tip screw driver.) Insert the screw from underneath and twisth the standoff on to it from the top.
Prepared chassis: