Voltmeter Script
- Download measure_volts_with_cyberscope.hex: right-click and select Save link as...
measure_volts_with_cyberscope.hex
- Open it with your programming software. Note that python.microbit.org/v/2 is used in this tutorial's screencaptures.
- Click Connect, then Flash.
- After the script is done loading into the micro:bit, click Disconnect.
Voltmeter Tests
- In the CYBERscope, click Connect.
- Use your probes to take the measurements shown in the animation. The measurements are also listed step-by-step below the animation.
In these tests, you will measure voltages across the LED circuit’s components and compare them to the voltage across the +/- supply rails.
- Use the animation and the instructions below it to measure voltage across the supply rails, then the resistor, then the LED.
- Optionally, view the full-size kvl-measurements.mp4 clip to play and pause it between steps.
- Check the voltage when the two probes are connected to the same row. It should be very close to 0.00 V.
- Measure the voltage across the (+) and (-) supply rails.
- Measure the voltage across the resistor.
- Measure the voltage across the LED.
- Add the resistor and LED voltage measurements.
- Compare it to the voltage across the (+) and (-) supply rails.