If you like Halloween and you like tacos, then you’ve come to the right place my friends! In this tutorial I do a “show and tell” of how I made a crawling piñata taco. Since the parts you end up using may vary (depending on whether you have access to a laser cutter) this tutorial is more of a guide rather than a step by step instruction manual. Let's get started!
Parts Used:
- (1) - Taco Pinata
- (2) - Creepy eyeballs
- (8) - Pipe Cleaners
- (3) - Jumper wires
- (2) - Feedback 360° servos (#900-00360)
- (1) - 5 AA Battery Pack (#)
- (1) - 40-pin single row header (#) OR, (10 to 15) - 3-pin single row headers (#451-00303)
- (4) - L-shaped Mounting Brackets (#720-00011)
- (1) - PIR Sensor (#555-28027)
- (1) - Activity Board WX (#32912)
- (10) - #4-40 pan head screws
- (8) - #4-40 nuts
- (8) - #4-40 flat head screws
- (2) - Small Robot Wheel & Tire (#28114) (optional - required only if not laser cutting custom parts)
Tools Used:
- Glue Gun
- Drill with ⅛” drill bit
- Phillips screwdriver
CAUTION: Always wear safety glasses when working with drills, hot glue, laser cutters or other tools!