In this section, you will install the isolation assembly and electronics in your ELEV-8 v3 Quadcopter, following the 4 steps below.

This section will take approximately 30 to 60 minutes, depending on your skill level and equipment.

Tools Needed in this Section

• Small Flat-Head Screwdriver (optional)
• Flat-Nose Pliers
• Diagonal Cutters

Parts Needed in this Section

• 1 – Chassis Assembly from Section 4
• 4 – Vibration Damper, 80g (#700-00098)
• 1 to 4 – Zip Tie, 5.9" length (#700-00099)
• 6 – 3-Wire Servo Extension Cable, 6", Beveled (#800-00043)
• 1 – ELEV-8 PDB Power Cable, 6" (#800-00300)
• 1 – RC Radio Receiver (not included)
• 1 – Fully Charged 3-Cell LiPo Battery w/ EC3 connector (not included)