Build the Piezospeaker Circuit

Parts Required

(1) piezospeaker (just peel off the “Remove the seal after washing” sticker if it has one)
(misc.) jumper wires

Building the Start/Reset Indicator Circuit

The picture below shows a wiring diagram for adding a piezospeaker to the breadboard.

Always disconnect power before building or modifying circuits!
Set the Power switch to 0.
Unplug the battery pack.
Unplug the programming cable.

  • Build the circuit shown below. Position it just as shown on the breadboard. The speaker should stay in place for the rest of the book, while other circuits are added or removed around it.

Schematic and wiring diagram to build a piezospeaker reset-indicator circuit on the Board of Education Shield