Add the Topside Hardware

Parts required

(1) robot chassis
(1) rubber grommet
(2) 1″ standoffs
(2) 1/4" pan-head screws

Add the hardware to the top of your chassis.

  • Push the rubber grommet through the round hole in the chassis. A groove in the grommet fits over the edge of the metal, leaving a ring visible on both sides.
  • Attach a 1-inch standoff to each outer-most hole in the front of the robot chassis.  Use a 1/4-inch pan-head metal screw (these have a little dome on top with an x for the Philips-tip screwdriver). Insert the screw from underneath and twist the standoff on to it from the top.